Frozen boiler condensate pipes
What the condensate pipe does, signs it has frozen, finding the pipe, thawing it, resetting the boiler, preventing it, and when to call an engineer.
By Michael Johnson · Updated 18 November 2026 · How we check our guides
In a hard frost, thousands of condensing gas and oil boilers stop working for the same simple reason: the plastic condensate pipe that carries waste water outside has frozen and blocked. The boiler senses the blockage and shuts down, often with a gurgling noise and an error code. It's usually easy and safe to fix yourself. This guide explains what the condensate pipe does, the signs it has frozen, how to thaw it safely, resetting the boiler, preventing it happening again, and when to call a Gas Safe engineer.
1. What the condensate pipe does
- Condensing boilers recover extra heat from the exhaust, producing slightly acidic water (condensate).
- This drains through a plastic pipe, usually 21–32 mm, to an internal drain or outside to a gully or soakaway.
- External pipes, especially long, thin or exposed ones, can freeze in cold weather.
2. Signs it has frozen
- The boiler stops working during freezing weather.
- A gurgling noise from the boiler or pipe.
- A fault or error code on the display (the code varies by make; Worcester Bosch, for example, shows "EA").
- The boiler restarts briefly, then locks out again.
3. Finding the pipe
- Follow the white or grey plastic pipe from the bottom of the boiler to where it leaves the house.
- Outside, it usually runs down the wall to a drain or gully. The blockage is often at the bend or the open end.
4. Thawing it
- If you can reach the pipe safely (no ladders on icy ground), pour warm water (not boiling) along it, working back from the open end.
- Alternatively, hold a hot water bottle or warm cloth against the frozen section.
- It may take several kettle-loads of warm water. Be careful: the water you pour can freeze on paths and steps.
- Don't use boiling water: it can crack the plastic pipe.
5. Resetting the boiler
- Once the pipe is clear, reset the boiler using the reset button as the manual describes.
- It should start normally. If it locks out again, the pipe may still be blocked, or there's another fault.
6. Preventing it
- Insulate external condensate pipework with waterproof, UV-resistant lagging.
- Fit a cover at the drain end so it can't block with ice or leaves.
- In freezing spells, some makers suggest turning the heating flow temperature up and running the boiler continuously at a lower room temperature, so the pipe doesn't sit still and freeze.
- A heating engineer can reroute the pipe internally, increase its diameter, or fit a trace heater.
7. When to call an engineer
- The boiler still won't work after thawing and resetting.
- You can't safely reach the pipe.
- Any work on the boiler itself must be done by a Gas Safe registered engineer (or OFTEC for oil).
- Meanwhile, see the keeping warm guide and the frozen and burst pipes guide.
8. Frequently asked questions
Why has my boiler stopped working in the cold?
Often the condensate pipe outside has frozen. Thaw it with warm (not boiling) water, then reset the boiler.
Can I use boiling water on a frozen condensate pipe?
No. Use warm water; boiling water can crack the plastic.
How do I stop my condensate pipe freezing?
Insulate the outside section, fit a drain cover, and ask an engineer about rerouting or increasing the pipe size.
9. Sources
- Worcester Bosch, boiler not working in freezing temperatures?: worcester-bosch.co.uk
- Baxi, how to thaw a frozen boiler condensate pipe: baxi.co.uk
- Which?, how to thaw a frozen boiler condensate pipe: which.co.uk
New to some of the terms? See the glossary. Not sure where to start? Try start here.