Home › Guides › Consumer units and RCDs

Consumer units, RCDs and RCBOs explained

What is in a consumer unit, MCBs, RCDs and RCBOs, why it trips, finding the fault, testing RCDs, power cut or tripped switch, when to call an electrician, and backup power.

By Michael Johnson · Updated 18 November 2026 · How we check our guides

The consumer unit (fuse box) is where your home's electricity is split into circuits and protected. Knowing what's inside it, what an RCD, MCB and RCBO do, why one trips and how to find the cause safely saves a lot of worry in a power cut or when something keeps tripping. This guide explains the parts of a consumer unit, how to reset safely, testing RCDs, finding a fault that trips the power, when to call an electrician, and how backup power connects.

Don't open the consumer unit cover. Everything behind the front panel can be live, even with the main switch off, because the incoming supply cables are always live. Work inside it is for qualified electricians.

1. What's in a consumer unit

2. MCBs, RCDs and RCBOs

DeviceProtects againstTrips when
MCB (miniature circuit breaker)Overload and short circuitToo much current flows: too many appliances, or a fault
RCD (residual current device)Electric shock and some firesCurrent leaks to earth (typically 30 mA for shock protection)
RCBOBoth, for one circuitEither overload or earth leakage

An RCD on its own doesn't protect against overload; it's paired with MCBs. With RCBOs, a fault only takes out one circuit, rather than half the house.

3. Why it trips

4. Finding the fault

  1. Unplug everything on the affected circuits, and switch off fixed appliances such as the immersion heater.
  2. Reset the tripped device.
  3. If it stays on, plug appliances back in one at a time until it trips: that's the likely culprit.
  4. If it trips immediately with everything unplugged, the fault is probably in the fixed wiring or a fixed appliance. Leave it off and call an electrician.
  5. If an MCB trips repeatedly, don't hold it on or replace it with a bigger one.

5. Testing RCDs

6. Power cut or tripped switch?

7. When to call an electrician

8. Backup power and the consumer unit

9. Frequently asked questions

Why does my RCD keep tripping?

Usually a faulty appliance, damp in outdoor electrics, or a cable fault. Unplug everything, reset, then reconnect items one at a time.

How often should I test my RCD?

The IET recommends pressing the test button every six months.

What is the difference between an RCD and an RCBO?

An RCD protects against earth leakage (electric shock). An RCBO combines that with overload protection for a single circuit.

10. Sources

  1. IET, consumer units and protective devices FAQs: theiet.org
  2. Electrical Safety First, RCDs explained: electricalsafetyfirst.org.uk
  3. IET, consumer guidance: consumer units: theiet.org

New to some of the terms? See the glossary. Not sure where to start? Try start here.