Infrared heating panels
How infrared panels work, where they work well, running costs, sizing, placement, with solar and batteries, safety and installation, and how they compare.
By Michael Johnson · Updated 19 November 2026 · How we check our guides
Infrared heating panels are slim electric heaters that warm people and surfaces directly, rather than heating the air first. They're popular in flats, offices, garden rooms and homes without gas, and are often marketed as cheaper to run than other electric heaters. The truth is more nuanced: every direct electric heater turns one unit of electricity into one unit of heat. This guide explains how infrared panels work, where they make sense, running costs, sizing, using them with solar and batteries, and safety.
1. How infrared panels work
- The panel surface warms to a moderate temperature and radiates heat, like sunshine, onto people, walls, floors and furniture.
- Those surfaces then warm the air, so rooms feel comfortable with less draught-driven heat loss.
- They heat up quickly and are silent, with no moving parts.
2. Where they work well
- Rooms used for short, regular periods, such as home offices, bathrooms and garden rooms.
- Spot heating where you sit, rather than heating a whole room or house.
- High-ceilinged rooms, where warm air would rise out of reach.
- Rooms with cold walls, where radiant heat helps comfort and can reduce condensation on surfaces. See the condensation guide.
- They work best in well-insulated rooms. See the draught-proofing guide.
3. Running costs
- Cost per hour = panel watts ÷ 1,000 × your price per kWh. A 600 W panel at 25p per kWh costs 15p an hour at full power.
- Thermostats cycle panels on and off, so average use is lower than the rating.
- Compared with a gas boiler or heat pump, direct electric heat usually costs more per unit of heat on standard tariffs.
- Use the heater running cost calculator and the heating fuel cost calculator.
4. Sizing
- Makers give rough watts per square metre of room depending on insulation, often in the range of 60–100 W per m² of floor.
- Poorly insulated rooms need more, and comfort depends on the panel facing where you sit.
- Room heat loss calculations give a better answer than rules of thumb.
5. Placement
- Ceiling or high-wall mounting gives the widest coverage; aim panels at where people sit.
- Don't block the panel with furniture or hang things on it.
- Keep the clearances the maker specifies; panels in bathrooms must have a suitable IP rating for their zone.
6. With solar and batteries
- Infrared panels are simple resistive loads, ideal for surplus solar diverted through a smart switch or relay.
- In winter, solar output is low just when heating is needed most; off-grid, direct electric heating rarely makes sense.
- Low-power options such as heated clothing or electric blankets keep people warm on far less energy. See the heated clothing guide and the low-power heating guide.
7. Safety and installation
- Buy panels with UKCA or CE marking and an overheat cut-out.
- Fixed (wired-in) panels must be installed by a competent electrician and, in some cases, notified under building regulations.
- Plug-in panels should be plugged straight into a wall socket, not an extension lead. See the extension leads guide.
- Panels can be hot to touch; consider children and older people.
8. How they compare
| Heater | Heat per kWh of electricity | Notes |
|---|---|---|
| Infrared panel | About 1 kWh | Radiant comfort, quick response |
| Oil-filled radiator, convector, fan heater | About 1 kWh | Heats air |
| Storage heater | About 1 kWh | Uses cheaper off-peak electricity |
| Air-to-air or air-to-water heat pump | Typically 2.5–4 kWh | Much cheaper to run; higher install cost |
9. Frequently asked questions
Are infrared heaters cheaper to run?
Per unit of heat, no: all direct electric heaters are similar. They can feel comfortable at slightly lower air temperatures and suit heating people rather than whole rooms.
How much does a 600 W infrared panel cost to run?
At full power, 0.6 kWh an hour; at 25p per kWh, 15p an hour. Thermostats reduce this.
Can I run infrared heating from solar panels?
Yes from surplus in spring and autumn, but winter solar is usually too low for heating.
10. Sources
- Energy Saving Trust, infrared heating explained: energysavingtrust.org.uk
- Homebuilding and Renovating, infrared heating: homebuilding.co.uk
- Changeworks, infrared heating panels: changeworks.org.uk
New to some of the terms? See the glossary. Not sure where to start? Try start here.