Extension lead safety
How much a lead can take, typical appliance loads, cable reels, adaptors and daisy-chaining, outdoor and generator use, checking leads, and power cuts.
By Michael Johnson · Updated 19 November 2026 · How we check our guides
Extension leads are in every home, and during a power cut or when running things from a generator or power station they suddenly carry a lot more. Overloaded leads, coiled cable reels and chains of adaptors cause thousands of fires. This guide explains how much a lead can take, why cable reels must be unwound, outdoor and generator use, which appliances should never go on an extension lead, and what to check.
1. How much a lead can take
- A UK plug is fused at up to 13 A. At 230 V, that's about 3,000 W for everything plugged into the lead combined.
- Some leads are rated lower (for example 10 A, about 2,300 W); check the label.
- Multiple high-power appliances on one lead (a kettle and a heater, say) will overload it.
- Use the extension lead load calculator to add up your appliances.
2. Typical appliance loads
| Appliance | Typical power |
|---|---|
| Kettle | 2,000–3,000 W |
| Fan heater | 1,000–3,000 W |
| Microwave | Around 1,000–1,500 W drawn |
| Toaster | 800–1,500 W |
| Fridge-freezer (running) | About 100–200 W, more at start |
| TV | 50–200 W |
| Laptop | 30–90 W |
| Phone charger | 5–30 W |
Check the rating plate on your own appliances.
3. Cable reels
- A coiled cable can't shed heat; under load it can melt and catch fire.
- Reels usually show two ratings: a lower one when wound and a higher one when fully unwound.
- Always unwind a reel completely before using it with anything more than a small load.
- Don't run cables under rugs or carpets, or pinch them in doors and windows.
4. Adaptors and daisy-chaining
- Avoid block (cube) adaptors; their weight can loosen the plug in the socket and they're easy to overload.
- Never plug one extension lead into another.
- If you're short of sockets, have more sockets fitted by an electrician.
- Use leads with a cable, not plug-in multiway blocks, and surge-protected leads for sensitive electronics.
5. Outdoor and generator use
- Use outdoor-rated (for example IP44 or higher) leads and connectors, and keep connections off wet ground.
- Use RCD protection for outdoor equipment. See the consumer unit and RCD guide.
- From a generator, use heavy-duty flexible cable sized for the load and length; long thin leads cause voltage drop and heat. See the generator guide.
- Never run a lead from a generator into a house socket ("backfeeding"): it can kill electricians working on the network. Use a proper transfer switch. See the transfer switch guide.
- Caravan hook-up uses a dedicated orange hook-up lead. See the hook-up guide.
6. Checking leads
- Look for scorch marks, melted or cracked plastic, damaged cable and loose plugs.
- Feel for warm plugs and sockets: warmth is a warning sign.
- Check the plug fuse rating suits the lead.
- Throw away damaged leads; don't tape them up.
7. During and after a power cut
- Running several things from one lead off a power station or inverter can overload both the lead and the power source; stay within both ratings.
- Switch off and unplug heaters and other high-power appliances during a power cut, so they don't all start when power returns.
- See the home backup power guide.
8. Frequently asked questions
How many watts can I plug into a UK extension lead?
No more than 13 A in total, about 3,000 W, for the whole lead, or less if it's rated lower.
Can I plug a heater into an extension lead?
It's best not to. Heaters draw close to the full 13 A on their own; plug them straight into a wall socket.
Why do cable reels need to be unwound?
A wound cable can't lose heat, so it can overheat and melt even below the lead's normal rating.
9. Sources
- RoSPA, don't overload: rospa.com
- Aberystwyth University, socket overload calculator: aber.ac.uk
- Warwickshire Fire and Rescue, never overload electrical sockets: warwickshire.gov.uk
- University of Aberdeen, electrical extensions guidance: abdn.ac.uk
New to some of the terms? See the glossary. Not sure where to start? Try start here.