Hydraulic ram pumps and gravity-fed water
How a ram pump works, what you need, how much water it delivers, installation, gravity-fed supplies, maintenance and frost, and water quality and permissions.
By Michael Johnson · Updated 18 November 2026 · How we check our guides
A hydraulic ram pump lifts water uphill using nothing but the energy of falling water: no electricity, no fuel and only two moving parts. Invented in the 18th century, rams still supply farms, cottages, gardens and livestock troughs where there's a stream or spring with a little fall. Alongside them, simple gravity-fed systems move water from a spring or tank to where it's needed without any pump at all. This guide explains how a ram works, what you need, how much water it delivers, installation, gravity-fed supplies, maintenance and frost, and water quality and permissions.
1. How a ram pump works
- Water runs down a drive pipe and out through a waste valve.
- As it speeds up, the waste valve slams shut. The sudden stop (a "water hammer") forces some water through a one-way valve into an air chamber.
- The compressed air pushes water up the delivery pipe.
- The waste valve reopens and the cycle repeats, typically 20 to 100 times a minute, with a characteristic clacking.
2. What you need
- A reliable, constant supply: a stream, spring or overflow.
- At least about 1 metre (3 feet) of fall from the source to the pump site.
- A rigid drive pipe (galvanised steel or rigid plastic) at least about five times as long as the fall.
- Somewhere for waste water to drain back to the stream.
- A delivery pipe to a tank at the top.
3. How much water it delivers
- Output depends on the flow into the ram, the fall, and the lift. Doubling the lift for the same fall roughly halves the delivered water.
- A common rough estimate is: delivered flow ≈ supply flow × fall ÷ lift × efficiency (often around 0.6).
- Example: 20 litres a minute with 2 m of fall lifting 12 m delivers about 20 × 2 ÷ 12 × 0.6 ≈ 2 litres a minute, nearly 2,900 litres a day.
- That's plenty for a garden, livestock or a household's non-drinking water.
4. Installation
- Build a small intake with a screen to keep out leaves, fish and debris.
- Run the drive pipe straight and rigid; flexible pipe absorbs the pressure pulse and stops the ram working.
- Anchor the ram firmly on a solid base.
- Fit a gate valve on the drive pipe for maintenance.
- Deliver to a tank with an overflow, so water isn't wasted when the tank is full.
5. Gravity-fed supplies
- A spring or tank above the house can supply water by gravity alone: about 0.1 bar of pressure for every metre of height.
- A header tank filled by a ram, a solar pump or rainwater then feeds taps, troughs or drip irrigation. See the solar water pumping guide.
- Use large enough pipe for long runs to avoid losing pressure to friction.
- Gravity systems keep working in a power cut, unlike electric pumps. See the off-grid water guide.
6. Maintenance and frost
- Clear the intake screen regularly, especially in autumn.
- Replace valve rubbers and check the air chamber; some rams need the air topped up through a snifter valve.
- Protect the ram and pipes from frost: a continuously running ram often keeps going in cold weather, but exposed pipes can freeze and split.
7. Water quality and permissions
- Stream and spring water isn't safe to drink without testing and treatment. See the water filters guide and the private water supply guide.
- You need the landowner's permission, and work in or near a watercourse may need consent.
- Abstracting more than 20 cubic metres a day in England usually needs a licence.
8. Frequently asked questions
How does a ram pump work without electricity?
It uses the momentum of falling water: a valve slams shut, the pressure surge pushes some water into an air chamber, and that pushes water uphill.
How much fall does a ram pump need?
About 1 metre (3 feet) as a minimum, with a constant flow of water.
How much water will a ram pump deliver?
Roughly the supply flow × fall ÷ lift × about 0.6. Higher lifts deliver less.
9. Sources
- NC State Extension, hydraulic ram pumps: ncsu.edu
- HowStuffWorks, how does a hydraulic ram pump work?: howstuffworks.com
- GOV.UK, check if you need a licence to abstract water: gov.uk
New to some of the terms? See the glossary. Not sure where to start? Try start here.