Solar diverters: heating hot water with spare solar
How a solar diverter works, what you need, the real sums against gas, electric and export rates, who gains most, diverters vs batteries, heat pumps, installation and safety, getting the most from one, and off-grid dump loads.
By Michael Johnson · Updated 18 November 2026 · How we check our guides
A solar diverter (also called a PV diverter or immersion diverter, sold as brands like the iBoost and eddi) sends spare solar electricity to your hot water cylinder's immersion heater instead of exporting it to the grid. When export paid almost nothing, diverters were an easy win. Now that export rates of 12–15p or more are common, and most new systems come with a battery, the sums are less clear-cut. This guide explains how diverters work, who gains most, how they compare with batteries and export, installation and safety, and how to get the most from one.
1. How a solar diverter works
- A current clamp (CT) on your meter tails measures whether you're importing or exporting.
- When you're exporting, the diverter feeds exactly that amount of power to the immersion heater, varying it smoothly (a 3 kW immersion might run at 600 W, then 1.2 kW, as the surplus changes).
- It does this many times a second, so you export almost nothing while the cylinder still needs heat.
- Once the cylinder is hot, the immersion's thermostat opens and the surplus is exported again.
- Many diverters can also divert to a second immersion, a storage heater or (with some models) an EV charger.
2. What you need
- A hot water cylinder with an immersion heater. Combi boilers have no cylinder, so a diverter can't help.
- A solar PV system that regularly exports a decent amount: roughly 3 kW of panels or more.
- Somewhere to mount the diverter near the cylinder, and a way to get the CT signal from the meter (wired or wireless sender).
- A qualified electrician to install it.
3. Does it save money? The real sums
Every kWh you divert is a kWh you no longer export. So the saving is the value of the fuel you no longer burn, minus the export income you give up.
| Hot water normally heated by | Cost of 1 kWh of heat | At 4p export | At 15p export |
|---|---|---|---|
| Gas boiler (8p, 85%) | About 9.4p | Saves about 5.4p | Loses about 5.6p |
| Oil boiler (7p, 85%) | About 8.2p | Saves about 4.2p | Loses about 6.8p |
| LPG boiler (11p, 85%) | About 12.9p | Saves about 8.9p | Loses about 2.1p |
| Electric immersion, standard rate (26p) | 26p | Saves about 22p | Saves about 11p |
| Electric immersion, off-peak (8p) | 8p | Saves about 4p | Loses about 7p |
A typical household can soak up 1,000–1,500 kWh a year in a diverter, mostly from March to October. That's worth roughly £100–£300 a year against standard-rate electric hot water, and anything from a small loss to about £80 against gas, depending on your export rate. Diverters cost about £300–£500 fitted. Work out yours with the diverter savings calculator.
4. Who gains most
- Homes with electric-only hot water (no gas), especially those on a standard rate.
- Homes on a low or no export tariff, including many older Feed-in Tariff systems with deemed export (where you're paid for 50% export whether you export it or not).
- Off-gas homes on LPG or oil, if the export rate is low.
- Larger families with high hot water use, who can soak up more surplus.
Those who gain least: gas households on a good export tariff, and homes that already have a battery soaking up the surplus.
5. Diverter vs battery vs export
| Diverter | Battery | Just export | |
|---|---|---|---|
| Cost | About £300–£500 | About £2,000–£5,000 | Nothing |
| What it uses surplus for | Hot water only | Anything in the home, any time | Paid at the export rate |
| Typical value | Fuel price ÷ efficiency | Import price saved (often 25p+), plus cheap-rate arbitrage | Export rate |
| Power cut backup | No | Yes, if fitted with backup | No |
| Lifespan | About 10–12 years | About 10–15 years | n/a |
With a battery, a diverter only gets what's left once the battery is full, which is mainly on long summer days. See the grid-tied solar and battery guide.
6. Diverters with heat pumps
- A heat pump makes hot water for about a third to a half of the electricity an immersion uses (COP 2–3).
- So 1 kWh of solar through an immersion gives 1 kWh of heat, but the same 1 kWh through the heat pump gives 2–3 kWh.
- Where possible, it's better to run the heat pump's hot water cycle in the middle of sunny days, using smart controls, than to divert to the immersion.
- A diverter can still help with the weekly legionella cycle and on very sunny days once the heat pump's own tank is satisfied.
7. Installation and safety
- Diverters are wired into the immersion circuit and must be installed by a qualified electrician; it's notifiable work in many cases.
- The immersion's thermostat must work, and the cylinder must have its safety devices (temperature and pressure relief valve on unvented cylinders).
- Set the immersion thermostat to 60–65 °C. Stored hot water should reach 60 °C regularly to control legionella; many diverters have a boost function for this.
- Diverters that chop the waveform can cause radio interference on HF; reputable units meet EMC limits, but radio users may want to choose models known to be quiet.
- Check your immersion element's age: elements fail, and a diverter makes the immersion work harder.
8. Getting the most from a diverter
- Set the boiler or heat pump to heat water late in the afternoon or evening, after the diverter has had its chance.
- Turn off the boiler's hot water in summer if the diverter keeps the tank hot.
- Insulate the cylinder and pipework so the heat lasts until the next morning.
- A larger cylinder (or a second immersion lower down) stores more spare solar. See the hot water cylinder size calculator.
- Run washing machines and dishwashers on sunny days first; they use solar at full import value.
9. Diverters off-grid
- Off-grid, there's no export: once the battery is full, solar is simply wasted.
- Off-grid systems use a "dump load" or the inverter's programmable relay to switch on an immersion or water heater when the battery is full.
- Victron and other off-grid inverters can do this with their own relays and settings. See the off-grid hot water guide.
10. Frequently asked questions
Is a solar diverter worth it?
It's worth it if you heat water with electricity or have a low export rate. With gas hot water and an export rate of 12–15p or more, exporting usually pays better.
Can I use a solar diverter with a combi boiler?
No. A diverter needs a hot water cylinder with an immersion heater. A combi heats water on demand, with no tank to store solar heat.
Should I get a diverter or a battery?
A battery saves more per kWh because it replaces imported electricity at full price and can provide backup, but costs much more. A diverter is a cheap add-on if you don't have a battery.
How much hot water can a diverter make in winter?
Very little. In the UK, surplus solar is mostly available from March to October.
11. Sources
- Sunsave, solar power diverters: are they worth it?: sunsave.energy
- pv magazine, surplus PV in UK homes: why the heat pump beats the immersion diverter for hot water: pv-magazine.com
- The Eco Experts, solar diverters: theecoexperts.co.uk
New to some of the terms? See the glossary. Not sure where to start? Try start here.