Caravan, motorhome and RV solar: sizing, fitting and the rules
How much solar a caravan, motorhome, camper trailer or RV needs for the way you travel, seasonal output, roof versus portable panels, mounting without leaks, PWM versus MPPT, leisure batteries, charging from the tow vehicle, wiring and fusing, hook-up and inverters, example systems and the standards in the UK, USA and Australia.
By Michael Johnson · Updated 17 November 2026 · How we check our guides
Solar lets a caravan, motorhome, camper trailer or RV stay off hook-up for days or weeks. It's one of the most rewarding upgrades, but also one where cheap kits, poor roof fixings and wrong charger settings cause leaks, flat batteries and voided warranties. This guide covers how much solar you need for the way you travel, roof and portable panels, controllers, batteries, charging from the tow vehicle, wiring and fusing, and the standards and rules in the UK, USA and Australia.
1. How caravan solar works
Panels on the roof (or a portable panel on the ground) feed a charge controller, which charges the leisure battery at the right voltage. Your 12 V lights, pump, fridge fan and USB sockets run from the battery. When you plug into hook-up or drive, the mains charger or the tow vehicle charges the battery too. Many modern caravans already have a "solar ready" cable and a power management unit that includes a basic controller.
2. How much solar do you need?
Start with your daily use. Typical figures for a touring caravan or motorhome at 12 V:
| Load | Typical daily use |
|---|---|
| LED lights | 5–15 Ah |
| Water pump | 2–5 Ah |
| Phones, tablets, laptop | 10–30 Ah |
| TV and satellite/aerial booster, 3 hours | 10–20 Ah |
| Heater fan and controls (gas or diesel heating) | 10–25 Ah in winter |
| Compressor fridge (if fitted instead of 3-way) | 30–50 Ah |
| Absorption (3-way) fridge on 12 V | Don't: 8–12 A continuously. Run it on gas when parked |
| Starlink Mini | 25–40 Ah over 12 hours (see the Starlink calculator) |
Use the power consumption calculator and the solar panel size calculator, or the off-grid solar system calculator to size everything at once.
3. Seasons and latitude
| Where and when | Peak sun hours (flat roof panel) | 100 W panel, Ah per day (approx.) |
|---|---|---|
| UK, summer | 4–5 | 23–29 Ah |
| UK, spring/autumn | 2–3 | 12–18 Ah |
| UK, winter | 0.5–1 | 3–6 Ah |
| Southern Spain/Portugal, winter | 2.5–3.5 | 15–20 Ah |
| US south-west, year-round | 4.5–7 | 26–40 Ah |
| Australia, outback winter | 4–5 | 23–29 Ah |
| Australia, Victoria/Tasmania winter | 1.5–2.5 | 9–15 Ah |
Flat-mounted roof panels lose a lot in winter because the sun is low; a tilted portable panel can produce two to three times as much. Check your location with the tilt angle calculator.
4. Roof, portable or both?
| Roof-mounted | Portable (folding panel or blanket) | |
|---|---|---|
| Convenience | Always charging, even when driving or away from the van | Must be set up and stored; can be stolen |
| Shade | Must park in sun | Park in shade, put the panel in the sun |
| Winter output | Low (flat) | High (tilt towards the sun) |
| Roof space and weight | Uses roof space; adds 5–20 kg | None on the roof |
| Leak risk | Needs a cable entry and fixings | None |
Many people use both: 200–400 W on the roof plus a 120–200 W folding panel for winter or shady sites. Portable panels need their own controller, or connect via an Anderson plug to a controller input, never straight to the battery.
5. Roof mounting without leaks
- Most caravan roofs are thin aluminium or GRP over foam or timber, and aren't designed to be walked on. Use boards to spread your weight, or work from a platform.
- Use proper bonded mounting brackets or spoilers stuck with a marine-grade polyurethane or MS-polymer adhesive (for example Sikaflex 252 or similar), with the maker's primer. Avoid drilling into the roof where possible.
- Keep panels at least 25–50 mm above the roof so air can cool them.
- Use a proper roof cable entry gland, sealed with the same adhesive, and run the cable inside through a wardrobe or locker.
- Semi-flexible panels can be bonded flat, but run hotter and degrade faster; mount them on a ventilated surface if possible.
- Check the roof's load limits and any warranty conditions (some makers require approved dealers to fit solar).
- Check vehicle height afterwards for bridges, ferries and car parks.
6. Charge controllers: PWM vs MPPT
- PWM controllers are cheap and fine for a single small 12 V panel (up to about 100–150 W) with a matched voltage.
- MPPT controllers harvest 10–30% more, especially in cold weather and with panels wired in series, and suit anything over about 150 W. They also allow longer cable runs.
- Choose one with a lithium profile if you have or might get a lithium battery.
- Many caravans' built-in power units contain a basic PWM solar regulator with a limited current rating; check before adding a big array. A separate MPPT controller is usually better.
- Size it with the charge controller calculator and check series voltages with the MPPT string voltage calculator.
7. Leisure batteries
| Type | Usable capacity of a 100 Ah battery | Weight | Notes |
|---|---|---|---|
| Flooded (wet) leisure battery | About 50 Ah | 22–25 kg | Cheapest; needs venting outside |
| AGM | About 50 Ah | 25–30 kg | Sealed; tolerates tilting |
| LiFePO4 | 80–100 Ah | 10–13 kg | Needs lithium charging settings and a DC-DC charger |
Weight matters: payload in a caravan is limited, and a towing combination has legal weight limits. Lithium saves 15–40 kg for the same usable energy. See the battery voltage chart.
8. Charging from the tow vehicle
- In the UK, a 13-pin socket's charge feed (pin 10) gives a little charge, but the thin cables lose a lot of voltage and many newer cars limit or cut it. In Australia, an Anderson plug from the tow vehicle with heavy cable is common; in the US, the 7-way connector's charge line works similarly.
- A DC-DC charger in the caravan, fed from a heavy-gauge cable from the tow vehicle battery, gives a proper charge despite voltage drop, and is essential for lithium and smart alternators. Many DC-DC chargers also have a solar input with MPPT.
- Fuse the feed at the tow vehicle battery end, and only allow charging with the engine running (ignition or D+ trigger) so you can't flatten the car battery.
- Use the DC-DC charger size calculator.
9. Wiring, fusing and cable sizes
- Panel to controller: 4–6 mm² (10–12 AWG) is typical for up to 400 W; check voltage drop with the DC voltage drop calculator.
- Controller to battery: sized for the controller's output current plus 25%, with a fuse or breaker close to the battery.
- Fuse panel strings if you have three or more in parallel, and add a DC isolator so the panels can be disconnected for work.
- Use proper MC4 connectors with the right crimp tool; mismatched or badly crimped MC4s are a common cause of fires.
- Secure all cables and protect them where they pass through panels or the floor.
- Main battery fuse: a high-breaking-capacity fuse within about 300 mm of the battery positive, especially with lithium.
10. Hook-up, inverters and 230 V / 120 V
- Caravan 230 V or 120 V circuits are fed from hook-up through the caravan's RCD and MCBs. An inverter feeding those circuits needs a changeover switch or an inverter-charger with an internal transfer relay, so it can never be connected to hook-up at the same time.
- Check RCD protection still works when on the inverter (neutral–earth bonding); see the inverter guide.
- Size inverters realistically: a hair dryer or kettle needs 1.5–3 kW; the battery and cables must be sized for it.
- Size your site supply with the hook-up calculator.
11. Standards and rules by country
United Kingdom
- Touring caravans and motorhomes are generally built under the NCC Approval Scheme, to BS EN 1645 (caravans) and BS EN 1646 (motorhomes), with BS EN 1648-1/-2 for 12 V systems. Changes should keep to these standards.
- Fixed 230 V wiring must meet BS 7671 Section 721, and should be inspected and tested periodically (the IET recommends every three years, or annually for frequent use).
- Adding solar doesn't normally need any approval, but check your warranty, habitation check requirements and insurance. Heavy additions affect your payload and towing weights.
United States
- RVs are built to NFPA 1192 and NEC Article 551, with the RVIA's low-voltage (12 V) standard. RVIA updated its handbook for 2026.
- Owner-fitted solar isn't regulated for most RVs, but follow NEC 690 principles (fusing, disconnects, listed equipment) and check your insurer's and manufacturer's requirements.
- Inverters should be listed to UL 458 for vehicle use.
Australia
- AS/NZS 3001.2:2022 covers electrical installations in caravans, RVs and other connectable installations, including 12 V battery, solar and inverter systems, with major changes for lithium batteries. Vehicles completed after 18 November 2023 must meet the 2022 edition.
- Adding a solar panel, adding circuits or upgrading to lithium counts as an alteration and must comply with the current standard. Like-for-like repairs don't.
- 230 V work must be done by a licensed electrician, and many states require an electrical safety certificate for caravans with 230 V. Check your state's rules for ELV work and certification.
- Caravans must also meet the Australian Design Rules and any state registration requirements (for example, weight and dimension limits).
12. Example systems
| Use | Solar | Battery | Charging | Inverter |
|---|---|---|---|---|
| Weekends, sites with hook-up | 100–200 W roof or portable | 100 Ah AGM or LiFePO4 | Built-in charger; 13-pin feed | None or 300 W |
| Off-grid weekends, summer | 200–300 W roof | 100–150 Ah LiFePO4 | MPPT; 20–25 A DC-DC | 500–1,000 W |
| Long trips, some winter use | 400 W roof + 200 W portable | 200–300 Ah LiFePO4 | MPPT; 30–40 A DC-DC | 1,500–2,000 W inverter-charger |
| Full-time, Australian outback | 600–800 W roof + portable | 300–400 Ah LiFePO4 | MPPT; 40–50 A DC-DC | 2,000–3,000 W inverter-charger |
13. Frequently asked questions
How many solar panels do I need for a caravan?
For typical weekend use of 40–60 Ah a day, about 200–300 W in summer. For winter or bigger loads, 400 W or more, ideally with a tilted portable panel.
Will a 100W solar panel keep my caravan battery charged?
In UK or southern Australian summer, a 100 W panel gives roughly 20–30 Ah a day, enough for lights, a pump and phones. In winter it gives only a few Ah a day, so you'll need more panels or another charge source.
Do I need an MPPT controller?
For anything over about 150 W, or with panels in series, an MPPT controller harvests noticeably more energy and allows longer cable runs. For a single small panel, PWM is acceptable.
Can I add solar to my caravan without voiding the warranty?
Check with the manufacturer. Some require approved dealers to fit roof panels or specify approved mounting methods. Bonded mounts and a proper cable gland reduce the risk of leaks.
Do I need an electrician to install caravan solar in Australia?
12 V solar isn't usually licensed electrical work, but it must comply with AS/NZS 3001.2:2022 as an alteration. Any 230 V work, including connecting an inverter to the caravan's 230 V circuits, must be done by a licensed electrician.
Can I charge my caravan battery from my car while driving?
Yes. A DC-DC charger fed by a heavy cable from the car battery gives a proper charge; the standard 13-pin or 7-way charge line alone gives only a small charge.
14. Sources
- IET, electrical installations in caravan parks, caravans and motor caravans: theiet.org
- Caravan Industry Association WA, latest electrical standards for RVs (AS/NZS 3001:2022): caravanwa.com.au
- Standards Australia, AS/NZS 3001.2:2022: standards.org.au
- RV Industry Association, 2026 RV Handbook: rvia.org
- Intertek, UL 458 power converters/inverters for land vehicles: intertek.com
- Victron Energy, careful – alternator charging lithium: victronenergy.com
New to some of the terms? See the glossary. Not sure where to start? Try start here.