Where to install a home battery safely
Why location matters, PAS 63100 principles, places to avoid, better locations, garages and outbuildings, temperature and ventilation, power stations and DIY systems, installation and insurance, and detection.
By Michael Johnson · Updated 18 November 2026 · How we check our guides
Home batteries are a great way to store solar power and keep the lights on in a power cut, but a large lithium battery holds a lot of energy, and in the rare event of a fault it can catch fire or give off toxic, flammable gases very quickly. Where a battery is installed matters as much as which one you buy. In 2024, the British Standards Institution published PAS 63100, setting out fire-protection rules for battery storage in homes. This guide explains where home batteries should and shouldn't go, the PAS 63100 principles, garages and outbuildings, indoor installations, portable power stations and DIY systems, temperature, ventilation, and what to do if something goes wrong.
1. Why location matters
- Lithium battery failures are rare, but when they happen, "thermal runaway" can spread from cell to cell, producing intense heat, flammable gas and smoke within minutes.
- A battery in an escape route could block the way out; one in a bedroom could affect sleeping people before they wake.
- A battery outside the living space, with fire detection, gives people time to get out and limits damage.
- Lithium iron phosphate (LiFePO₄) batteries, used in most home and off-grid systems, are much more stable than other lithium types, but location still matters. See the lithium battery safety guide.
2. PAS 63100: the key principles
PAS 63100:2024, "Electrical installations: protection against fire of battery energy storage systems for use in dwellings", applies to battery systems installed in homes in the UK. Installers working to it follow principles including:
- Outside the living space is preferred: for example, in a garage, an outbuilding or an outdoor enclosure designed for it.
- If indoors, keep batteries away from rooms people live and sleep in and from escape routes, with fire detection in the battery location linked to the home's alarms.
- Labelling: warning labels at the consumer unit so firefighters know there's battery storage.
- It doesn't cover homes with a floor area over 200 m², systems above low voltage, or small batteries of 150 Wh or less built into products with their own standards.
The full document is published by BSI. A qualified installer will apply it; ask how your installation complies.
3. Places to avoid
Guidance based on PAS 63100 lists locations where batteries shouldn't be installed, including:
- Bedrooms, and cupboards or spaces that open into bedrooms.
- Escape routes: hallways, landings, staircases and corridors, including protected escape routes and firefighting stairs and lobbies in flats.
- Lofts, roof spaces and other voids, where a fire could develop unseen.
- Basements and cellars with no direct access to the outside.
- Within 2 m of stored flammable materials, fuel tanks or gas cylinders.
- Outdoors within 1 m of doors, windows, escape routes or ventilation openings.
Also avoid places that get very hot (boiler cupboards, next to cylinders, south-facing glass) or very cold and damp.
4. Better locations
| Location | Pros | Watch for |
|---|---|---|
| Integral or attached garage | Outside living space, near the consumer unit | Keep away from cars, fuel, flammable storage; consider fire separation from the house |
| Outdoor wall in a rated enclosure | Keeps fire risk outside | At least 1 m from doors, windows and vents; weather and temperature rating |
| Detached outbuilding or shed | Separation from the house | Cable runs, frost, damp, security |
| Utility room (if unavoidable indoors) | Accessible | Not in an escape route; fire detection; away from flammables |
5. Garages, sheds and outbuildings
- Mount batteries off the floor (to avoid flood water and vehicle impact) and protect them from bumps.
- Keep petrol, paint, solvents, gas bottles and stored clutter well away.
- Fit a heat alarm (smoke alarms give false alarms in dusty garages), ideally interlinked with the house.
- Check the battery's temperature range: many lithium batteries can't be charged below 0 °C. Some have built-in heaters.
- For off-grid sheds and cabins, see the shed solar guide and the off-grid cabin guide.
6. Temperature, damp and ventilation
- Most lithium batteries work best at about 10–30 °C. Heat shortens life; freezing temperatures stop charging.
- Lead-acid batteries give off hydrogen when charging and need ventilation to the outside. See the lead-acid care guide.
- Keep batteries dry, out of direct sun, and with space around them for cooling as the maker specifies.
- Avoid condensation: unheated outbuildings can be damp in winter.
7. Portable power stations and DIY systems
- Portable power stations are covered by their own product standards rather than PAS 63100, but the same sense applies: charge them on a hard surface, away from flammable materials, not in escape routes or bedrooms overnight, and don't cover them.
- Don't leave large power stations charging unattended for long periods in living areas.
- DIY battery banks need proper fusing at the battery, a battery management system, correctly sized cables and an enclosure. See the DIY solar kit guide, the fuse size calculator and the used batteries guide.
- Second-hand EV or unknown cells carry higher risks.
8. Installation, labelling and insurance
- Use an installer certified under MCS (Microgeneration Certification Scheme) or a competent electrician working to BS 7671 and PAS 63100.
- Grid-connected batteries must be notified to your electricity network operator.
- Warning labels should be fitted at the consumer unit and battery location.
- Tell your home insurer: some policies require notification of battery storage.
- Keep the manuals and know where the battery's isolator is. See the grid-tied solar and battery guide.
9. Detection and emergency plans
- Fit a heat or smoke alarm at the battery location, interlinked with the home's alarms where possible.
- Know how to isolate the system, but only if it's safe: never approach a battery that is smoking or hissing.
- Make sure everyone knows the escape plan. See the fire and CO safety guide.
- Tell the fire service on 999 that there's a battery system, and where it is.
10. Frequently asked questions
Can I put a home battery in my loft?
Guidance based on PAS 63100 says not to install batteries in lofts, roof spaces or voids, where a fire could develop unseen.
Where is the best place for a home battery?
Outside the living space where possible: a garage, an outbuilding or a rated outdoor enclosure, away from doors, windows and flammable materials, with fire detection.
What is PAS 63100?
A BSI specification published in 2024 for protecting homes against fire from battery energy storage systems, covering where and how they should be installed.
Can I keep a power station in my bedroom?
It's best not to charge large power stations in bedrooms or escape routes, especially overnight. Charge them in a living area on a hard surface while you're awake.
11. Sources
- BSI, PAS 63100:2024 overview: bsigroup.com
- Self-Build, new fire safety standards introduced for domestic battery storage systems: self-build.co.uk
- Battery Design, PAS 63100:2024: batterydesign.net
- IET Engineering Communities, PAS 63100:2024 now available: theiet.org
New to some of the terms? See the glossary. Not sure where to start? Try start here.