Storage heaters in a power cut
How storage heaters work, what happens in a power cut, making stored heat last, preparing for storms and cold snaps, teleswitch meter problems, heat batteries and alternatives, backup heating, and safety.
By Michael Johnson · Updated 18 November 2026 · How we check our guides
Many UK homes, especially flats and homes off the gas grid, are heated by electric storage heaters. They charge up overnight on cheap off-peak electricity and release the heat during the day. That design has a useful side-effect in a power cut: a fully charged storage heater keeps giving out warmth for hours after the power goes off, unlike a gas boiler, which stops instantly. But if the cut happens overnight while they're charging, or the meter switching fails, you can wake to cold heaters. This guide explains how storage heaters behave in power cuts, how to make the most of stored heat, heat batteries and modern alternatives, the end of teleswitch meters, and backup heating.
1. How storage heaters work
Inside a storage heater are heavy ceramic or clay bricks surrounded by insulation. Electric elements heat the bricks overnight on an off-peak tariff such as Economy 7. During the day, heat escapes through the casing and, when you open the damper or turn up the output, faster through vents (some have a fan).
- Input controls how much heat is stored overnight.
- Output controls how fast the heat is released.
- Modern "high heat retention" models have better insulation and digital thermostats, holding heat much longer and releasing it when needed.
2. What happens in a power cut
| When the cut happens | What you'll notice |
|---|---|
| During the day, after a full overnight charge | Heaters keep giving out heat; older ones cool over the day, newer ones last longer |
| Overnight, during charging | Heaters only partly charged, or cold by morning |
| Long cut, over a day | Heat runs out; no recharge until power returns |
- Fans on fan-assisted heaters stop, so heat only comes out slowly through the casing.
- Electric hot water (an immersion heater) also stops, but a well-insulated cylinder stays hot for a day or more. See the hot water guide.
- When power returns, heaters may not recharge until the next off-peak period, unless you use a boost (expensive at peak rates).
3. Making stored heat last
- Turn the output to its lowest setting, and open it up only when you're in the room and need warmth.
- Choose one warm room with a well-charged heater, and keep its door closed.
- Close curtains and blinds, especially at dusk; draught-proof doors with a rolled towel. See the draught-proofing guide.
- Close doors to rooms you aren't using, and keep their heaters' outputs closed.
- Don't cover or hang washing on heaters.
- Layer up and use hot water bottles and blankets. See the low-power heating guide and keeping warm in a power cut.
4. Before a forecast storm or cold snap
- Turn input up the night before, so heaters are fully charged.
- Fill flasks with hot drinks and a hot water bottle in the morning.
- Charge power banks and power stations overnight on cheap electricity.
- Check the Met Office warnings. See the winter blackouts guide.
5. Teleswitch meters and timing problems
Many storage heaters were switched by "radio teleswitch" (RTS) meters, which received a long wave radio signal telling them when off-peak started. The RTS service has now been switched off, with the phase-out completed in June 2026. If your home still has an RTS meter:
- Heating and hot water may come on at the wrong time, stay on, or not come on at all.
- You could end up paying peak rates for heating.
- Contact your energy supplier as soon as possible to have it replaced with a smart meter set up for your heating.
See the prepayment and smart meters guide.
6. Heat batteries and modern alternatives
- High heat retention storage heaters hold heat for much longer and are more controllable than old models.
- Heat batteries (phase-change or brick types) store heat for hot water and heating, charging on cheap or solar electricity.
- Heat pumps are more efficient but stop in power cuts. See the heat pump guide.
- Solar diverters can heat water with spare solar. See the solar diverter guide.
- Grants may be available for upgrades; check with your council or energy advice service.
7. Backup heating
- Electric-only homes have no heating at all once stored heat runs out. Plan a backup for long cuts.
- Options: a wood burner if you have a chimney; a flueless paraffin or gas heater only where safe and allowed, with ventilation and a CO alarm; or simply staying warm with layers and low-power heating on batteries.
- In flats, portable fuel heaters may be prohibited; check your tenancy. See the paraffin heater guide and fire safety in flats.
- Know where your local warm spaces are. See warm spaces.
8. Safety
- Leave at least 30 cm in front of heaters and keep curtains clear of the top.
- Never dry washing on them or cover vents.
- If a heater smells of burning or the case gets unusually hot, switch it off at the wall and have it checked.
- Very old heaters (pre-1974) may contain asbestos insulation; don't open them. Get them checked before removal.
9. Frequently asked questions
Do storage heaters work in a power cut?
They keep releasing the heat they've already stored, often for much of the day, but can't recharge until the power returns.
How do I keep heat in my storage heater longer?
Turn the output to its lowest setting, open it only when you need heat, and keep doors and curtains closed.
What should I do if I still have a radio teleswitch meter?
Contact your supplier to replace it. The RTS signal has been switched off, so heating and hot water may not come on at the right times.
10. Sources
- Citizens Advice, using storage heaters and immersion heaters: citizensadvice.org.uk
- Home Energy Scotland, how to save energy with electric storage heaters: homeenergyscotland.org
- Octopus Energy, the Radio Teleswitch Service has come to an end: octopus.energy
- Which?, storage heaters: which.co.uk
New to some of the terms? See the glossary. Not sure where to start? Try start here.